L293D-Arduino Uno Shield-For Stepper,Servo and DC Motors

L293D-Arduino Uno Shield-For Stepper,Servo and DC Motors

The shield contains two L293D motor drivers and one 74HC595 shift register. The shift register expands 3 pins of the Arduino to 8 pins to control the direction for the motor drivers. The output enable of the L293D is directly connected to PWM outputs of the Arduino.

200.00

  • Description
  • Additional information
  • Reviews (0)

Description

The shield contains two L293D motor drivers and one 74HC595 shift register. The shift register expands 3 pins of the Arduino to 8 pins to control the direction for the motor drivers. The output enable of the L293D is directly connected to PWM outputs of the Arduino.

To increase the maximum current, the L293D allows extra chips with “piggyback”. Piggyback is soldering one or two or three extra L293D drivers on top of the L293D drivers on the board to increase the maximum current. The L293D allows parallel operation.

The Motor Shield is able to drive 2 servo motors, and has 8 half-bridge outputs for 2 stepper motors or 4 full H-bridge motor outputs or 8 half-bridge drivers, or a combination.

The servo motors use the +5V of the Arduino board. The voltage regulator on the Arduino board could get hot. To avoid this, the newer Motor Shields have connection points for a separate +5V for the servo motors.

 

Additional information

Weight 50 g

Reviews

There are no reviews yet.


Be the first to review “L293D-Arduino Uno Shield-For Stepper,Servo and DC Motors”